An Overview On How To Install Neon Under Car Lights
|
We?ve been doing some snooping around and got some skinny on the new Mini Cooper, due out in 2007.
First, if you want a truly international car, step right up. The new British-based Mini is going to feature an .....
Are you a bit confused about how to install Neon under car lights on your
vehicle? What about the wiring, do you know colors are important when wiring
up neon car lights? Well if not we'll show you how to install the under car lights
onto your vehicle in the fastest and most easiest way.
First of all, before doing *any* electrical work on your vehicle, always
disconnect the battery before starting. Do this by disconnecting the negative
battery cable.
Performing projects on cars, like installing Neon under car lights, involves
drilling holes into the body of a vehicle, its very important to first check the
locations where you're going to mount the under car lights, to be certain you
won't pierce or damage any crucial parts such as brake lines, fuel lines and
electrical lines, etc.
While the vehicle is raised up on a lift or jack determine the best location for
the neon tubes. Make sure they are away from all fuel lines, exhaust systems,
areas of extreme heat, moving parts, and areas where a lift jack is used to raise
the vehicle.
The easiest way to mount the under car neon lights is to start the screws in the
brackets first,(supplied in the kit) then holding the bracket in place, insert and
tighten the screws into the holes. Make sure that the wires coming from the
*side* neon tubes are facing the front of the vehicle. It's best to tighten the
screws just enough to hold the bracket in place, then go back after once you
almost finished and individually tighten each one until it seats firmly.
Since its inception, the market of used cars has suddenly escalated at an unprecedented rate for the past few years. In fact, surveys show that the number of people who buy used cars is almost tripled when compared to the .....
Next you'll need to locate a spot to mount the neon light kit transformer.
The preferred location will be somewhere near the battery in the engine
compartment and you'll need to drill mounting holes for attaching the transformer.
The power wire on the transformer can be connected directly to the Positive
side of the car battery or to any 12V power wire under the dashboard. There will
American automakers sometimes get the brunt of the criticism for producing models that are ugly, useless, or even downright dangerous. Ford has had its share .....
also be an "Earth wire" or Negative ground wire for the neon car lights that will
need to be securely screwed to the chassis of the vehicle, or to any "Earth wire"
to complete the power circuit.
The on-off switch should be mounted in a convenient location on the dash and
within your reach. Wiring for the switch can be run through a grommet in the
firewall, into the engine compartment where it can be connected to the battery.
The switch and fuse, that will be included in your neon under car lights kit,
should be connected between the transformer and the power supply.
All you need to do now is to plug all the neon tubes into the transformer and
complete any additional wiring according to your kit instructions and then you'll
be all set to show em off!
Please see our "More-In-depth" and step-by-step picture illustrated instructions
on
How to install Neon under car lights onto your vehicle.